Get PPE

If you are an organization or business that NEEDS supplies in order to provide essential services, use this form to give us information about your needs

Our Products

2-Layer Cloth Face Mask

 

Use: More breathable but less protective than the 4-Layer mask. Appropriate in situations where social distancing can be maintained, or if tasks require manual exertion or extended wear in higher temperatures. 

 

Materials: Two layers of cotton. Snug fit contoured at cheeks and around chin. Two elastic straps secure mask around neck and head. Embedded moldable wire nose bridge for custom fit. Alternating grain-cut and bias-cut layers should help reduce incursion of large, high-volume, high viral-count droplets. Inner pocket to insert additional filtering layer  (e.g. single layer cut from paper towel, coffee filter or HEPA vacuum bag, fine copper mesh). 

Care: The mask must be disinfected daily by one of these methods: 

  1. Hand-wash in bowl of hot, soapy water. Scrub all parts for one minute. Rinse. Air dry. 

  2. Or heat in oven at 170 F 30 minutes. (Do NOT use a microwave oven, due to the metal wire inside.)

  3. Or machine-wash on warm. Air dry. (Machine-drying will shrink mask and reduce elasticity of straps.)

4-Layer Cloth Face Mask

Use: Appropriate in situations where exposure risk is higher or social distancing cannot be maintained.

 

Materials: Four layers of cotton. Snug fit contoured at cheeks and around chin. Two elastic straps secure mask around neck and head. Embedded moldable wire nose bridge for custom fit. Alternating grain-cut and bias-cut layers should help reduce incursion of large, high-volume, high viral-count droplets. Inner pocket to insert additional filtering layer  (e.g. single layer cut from paper towel, coffee filter or HEPA vacuum bag, fine copper mesh). 

 

Care: The mask must be disinfected daily by one of these methods: 

  1. Hand-wash in bowl of hot, soapy water. Scrub all parts for one minute. Rinse. Air dry. 

  2. Or heat in oven at 170 F 30 minutes. (Do NOT use a microwave oven, due to the metal wire inside.)

  3. Or machine-wash on warm. Air dry. (Machine-drying will shrink mask and reduce elasticity of straps.)

 

 

 

 

 

 

 

 

Face Shields

PPE4CC Face Shields are designed by Prusa Printers and fabricated by Idea Fab Labs Santa Cruz.

 

Materials: The material in both the transparent lens and the forehead piece is PETG plastic. The plastic parts and the stretch strap are safe to reuse only if sterilized after each use.

Care: Face Shields must be sterilized after each use. Wear gloves and a face mask. Separate shield into 3 parts (clear lens, plastic forehead piece, stretch strap.) Submerge all 3 parts in hot, soapy water. Scrub all surfaces for 1 minute. Rinse and air dry.

 

OR Spray all 3 parts with a solution of 75% isopropyl alcohol or 25% hydrogen peroxide until all surfaces are thoroughly wet. Allow to air dry. Repeat spraying and air-drying a second time.

 

NOTE: Do not use bleach. It will cloud the lens.
 

 

Contact Us
Connect with us

1975 Soquel Drive, Ste. 215

Santa Cruz, CA 95065

team@ppe4cc.org

© 2020 by PPE4CC Proudly created with Wix.com

  • Black Twitter Icon